Procedure Single Step

It’s been a while since I’ve been on this forum. I hope this hasn’t been already asked and answered.

Jim, is there an estimate of when (or IF) single stepping through an entire procedure will be possible? In my procedures, some steps can be single-stepped, but other times a whole section of code runs through.

Thank you for this reminder. Unfortunately single stepping is never going to work reliably, so the single step tool has been removed from the default toolbar configuration in Panorama X 10.2.

The good news is that 10.2 includes a valuable new debugging tool that in my opinion is much more useful than single stepping, even if single stepping worked. I’m sure some of you will still want single stepping, but it’s just not going to happen.

Nooooooooooooo …

1 Like